Single Sealed Form Brick Treat Application

For Use Only When Using The Single Sealed Form Of Our Brick Sealer

Single Sealed Dilution Formula 4:1 (4 Parts Water, 1 Part "Treat") The following is meant as a suggested application method for newly placed brick or existing brick.

You can spray, roll or brush on Brick Treat making sure to cover the entire surface. The preferred method is to spray using a simple pump-up garden sprayer or an airless sprayer at low pressure achieving a fine mist.

Do not over apply or you may experience a white film when the "Treat" has dried. Simply apply enough to achieve a damp look. You should cover approximately 300 square feet per gallon on poured concrete and approximately 150 square feet of coverage on brick surfaces.

If accidentally applied to glass surfaces REMOVE IMMEDIATELY to help prevent etching.

New Construction

Brick Treat may be applied as long as the ambient temperature is at least 28 degrees F and there is no standing water on the surface. Damp brick can be treated, but you may not "Treat" through standing water.

Newly placed horizontal brick surfaces can be "Treated" as soon as the concrete is ready to be walked on, and the temperature is at least 28°F.

Or, if you can spray the Brick Treat and reach the entire surface to be "Treated" as in the case of a sidewalk, as soon as you have achieved the final finish of your choice and there is no standing water on the surface of the brick, you are ready to apply.

Vertical surfaces can be "Treated" 24 hours after the forms are removed. Be very careful not to apply so much product that it drips down the wall. A thin mist is best.

If the brick or other surface to be "Treated" has already cured, you will need to clean any dust or other debris from the surface to make sure the pores of the surface are open to receive the Brick Treat. You can use a stiff bristle broom or power wash the surface. It is best to power wash horizontal surfaces to be sure the pores are open and clean just be sure there is no standing water. Damp surfaces can be "Treated."

Contact Us For A Free Estimate

Please complete this form and a specialist will contact you shortly.

Fields with (*) are required.
Full Name*
Company Name
Phone Number*
Email Address*
Comments

You can paint or stain the surface. Be sure the surface is ready by sprinkling a little water on the "Treated" surface. If the water beads up, you may paint or stain.

Existing Construction

Existing surfaces may be "Treated" by following the same guidelines. The most important step is to start with a clean surface. The pores of the surface must be free of any debris. You must remove anything that will prohibit the Brick Treat from entering the pores of the surface, including paint, stain, glue or efflorescence (white powdery surface). Clean efflorescence with full-strength white vinegar and a hard bristle brush. Rinse thoroughly. Apply Concrete Treat.

  • Start w/ clean surface -- Pores must be open
  • Lightly treat entire surface (spray, roll, brush)
  • Ambient temperature must be at least 28°F
  • Surface may be damp -- no standing water
  • Do not over apply -- no puddling or dripping
  • Do not apply on glass, as it will cause etching

Have any questions? We'd love to speak with you! Call us at 855-906-5851 any time, or contact us online. We'd also like to invite you to visit our online store, where this and many other of our building supplies can be found!